Відео

Hi Paul....Martien here from the Netherlands. My Crossfire showed the next error twice in a row. When the engine is realy warm and I stop and turn of it will not give the key.... and it says ESP/ BAS light is on. The wing went up and down one time. It is an automatic 2007. After 3 hours I start the car...turn it of and it wil give the key. Stickey key issue is impossible because I fixed that 3 weeks ago. I took it out to prevent stickey key issue. I am a member of the Crossfire club in the Netherlands and some hints are RCM or neutral safety switch problems. What do you think????

Thankyou Paul! It wasnt rhe starter this time thank goodness. It was the crank sensor again... 😔

How do you know what each one is called? The biggest one in the center on the bottom of my silverado is wobbly. Not bad but i can notice it when its running and im concerned bout that. So how to know the name. Each part has a name.

What if there is oil leak under one of the pulley I have vauxhall astra j

Hi guys, does anyone know where I can get this kit please?

Thank you! I was trying to figure this out on my own without success

Thanks!

I had this issue, although i was confused as my key wasn't sticking in the barrel, it wasnt turning. It got progressively worse, and i almost got stranded, so i didn't want to push my luck. So i used your video as a guide. I've never done this before, and it took me twenty minutes. Thank you!

Hallo paul vielleicht kannst Du mir helfen.. Dein Video ist super, leider hat es bei mir nicht geholfen..Warum? Der Schlüssel lässt sich eeiterhin nicht drehen

Is it the same with an a200 2005? I have same issue, no start, but relay is ok. Bridge relay will get engine to start.

Thank you for the video. My car is 97 e320 and I do not see a relay like other E320s instead has this module that you have shown. Recently was stranded in the highway ended up toeing the car home. Car would crank but would not start. Later after the car was toed home, I cranked this time car did start and running fine. Does my problem could be the same as you shown? I did not dare to drive the car since. You said this is for no crank and no start. But mine did crank but did not start in the freeway. Planning to replace CPS and Fuel filter.

Thanks si very much for your time and great tip

Excellent video!!!

Nice tip sir

I am subscribed too.

Greetings from Bundaberg. Maaaate, you are brilliant. Exactly what was wrong with my Crossfire. I soldered it this morning. FIXED, Thankyou, Thankyou. 😂 P.S. my mates drivers side window don't work, any ideas.

Thank you for the video

Going with these Konis on the four corners on my 04 alabaster white limited ( red interior, manual) this wknd. I put braided brake lines as well ...she is 20 yrs old and still in love with her. I do have the mopar trunk cover as well. Question: w/o the adjustable cap, i assume the metal bar sticks out? Or did you leave the fap for the front on the rear left you dont show?

Makes you wonder why the car manufacturer intentionally over complicates the headlights

I have a c230 2005 Mercedes no crank no start not sure what it can be

My 01 clk 430 is having this problem. Is it the same for mine?

$1000.00?

I unplugged the alarm, that's it, no need to replace it (optional) no problems since

Thanks for the info 👍 very helpful

Why not just buy a upgraded 6.5" set of speakers

Just got my skreem work done by Mercedes swap shop in cali. Put everything back in and key turns the engine but it doesnt start the car. Also noticed after cranking the car the key doesnt bounce back to on position. Any help ?

Great video ….

Nice video, buddy. I made a few contributions to the community, too. In the day...

When testing the starter do it matter if it's a manual will it still crank with out pushing in the clutch

So happy to find your XF Videos. Best helpful Videos ! Hope to see much more in the future 🙏 all the Best from Germany 🍀

Great job wish u was in myrtle beach 😂😂

Glad your feeling better than ever Paul !! Hope to see ya later this summer :)

Many thanks! That really helped me out 👍🏻👍🏻👍🏻

Where can you buy the wiper arm remover tool?

Thx Paul. Another very helpful video!

Great video!!! Those of us in the Xfire community are fortunate to have you on here sharing videos to help repair and maintain our vehicles. Thank you!

Hello Paul, … yep , I always check anywhere on my crossfire that could possibly accumulate water . I’m going to Check out that alarm. It’s best for me to do preventative maintenance. Thanks Paul.

My headlight went out today. I will be doing this in a day or so. I already regret the entire car over this 😆 That clip everyone complains about I foresee falling off and disappearing into the ether.

Hello Paul ; haven’t seen any new videos in a while. Hopefully you and yours are doing fine. I have a question for you , not to long. My crossfire runs great, thanks to you, and passes smog easily. I’ve notice quite a while back, but thought that now is a good time to figure it out. When I start my car, I hear a puffing sound coming from engine, exhaust, I can’t figure it out. Is there any thing that you can suggest? I checked all hoses , vacuums that I can see. Puffing sound is only heard while engine is started at idle.. Can’t hear sound when I’m driving. Like I said , car is in extremely great running condition. Please suggest anything you might think I could check out. Thanks Paul

okay to get this right . i just delete the pin and the spring ????

Thank you 🙏🏽

Thanks Paul.

Easy way to unplug these wires is to use the little holes on top of the connecting plug. I use a paperclip insert one end into the hole and use pliers to pull it.

Wouldn't you first check to see if you have power to the switch on the upper part of the shifter counsel, then check the switch it self. Then the wiring to the seat, then if all that tests good you would go to looking at the seat. yes?

My serpentine belt just broke. I heard a squealing noise but didn’t get proactive on it. Does the pulley wheel spin slow rugged when testing bearing failure?

You didn’t really explain how the pulleys go bad my man. Care to share that with the rest of your viewers?

Hi and thank you for your videos. They’ve been quite helpful. I have all four crossfire I ordered the area told me for the secondary air pump and that works fine now I now been getting a code of P0600 on there Car starts and runs but I have all my lights on on the dash and I’m having problems with the admissions passing the car If I disconnect the plugs and reconnect them, it seems to reset everything in the car runs fine with no lights but after a while they come back. Have you seen anything like this? If you like to talk I can send my # Thank you in advance if you can help me with this

Hi Paul, Do you know how to fix a XF heater fan switch or where to find replacement? Thanks Larry

Thank you 🙏🏽 😎

If you can get a good deal replace the whole thing one in one out it makes it so much easier. The whole fan comes out with 4 screws